New technology from Japan now extends the battery life of your cellular phone battery, up to an additional 36 percent.

Denpita, a very simple to install patch material, which goes between your battery and battery case, will now extend the battery life per charge.

Its that simple!

Charging and discharging of the lithium-ion battery causes a forward and backward ion flow phenomenon, that creates waste matter (slags), that gets stored in the battery. This waste material matter hinders the proper ion flow and brings down the life of the battery, thus, decreasing the life of the battery. This is the main reason your battery starts giving you shorter talk times.

Denpita is a specially developed material, called PAT.P, that generates a cavity radiation energy, dissolving the waste matter stored in the battery and is constantly reforming ions, thus, increasing the battery life.

The chart below is a comparison of phones with and without the Denpita patch. These were discharged more than 200 times over a period of one year at a rated voltage of 3.6V, charging capacity of 550mAh and charging time of 2.5 hours.

Test Conditions:

Continuous discharge with 14 ohm resistance

Ambient Temperature: 25 Degrees Celcius

Ambient Humidity: 55%

Tested By: NEC

Note:

You may not get the exact result after Denpita is applied, since your battery quality and performance will vary, depending on it’s original quality and uniformity, difference of ambient conditions and the battery’s power-down status previous to Denpita being applied to it.

How To Apply:

1. Remove battery from cell phone.
2. Peel off the seal from backside of Denpita patch.
3. Apply to the battery case so that the surface of Denpita patch is facing the back of the battery.
4. If the Denpita patch is too large, you may trim it to fit before removing the seal.
5. Replace the battery.

Note: Do not apply the Denpita patch across any of the metal battery contacts.