| Sales Rep | Extension |
|---|---|
| Allen | 225 |
| Moses | 232 |
| Derick | 231 |
 VehicleFive sections, colored injection moulded plastic. Length: 700mm (2.29 ft) Diameter: 150mm (6 in) Weight: 10.5kg (23.1 1b) Umbilical Length: 50m (165 ft) Crush Depth: 90m (303 ft) Body Hull Constructed from polycarbonate based plastic with excellent impact strength, dimensional stability and mechanical performance. Further additives ensure chemical resistance and protection from ultra-violet light degradation. Front hemispherical viewing dome moulded in clear polycarbonate. Transparent cover called the contact lens, provided for additional protection. The two fore planes are for vehicle protection and improved stability and are designed to be a snap fit. In the event of a collision the fore planes will protect the velure and may dislodge. Under no circumstances should the fore planes be glued or permanently fixed to the vehicle as this may cause damage to the nose dome assembly. Four extra fore planes are supplied in the event of loss. Umbilical Cable Detachable from vehicle and control module. Cable fitted with one waterproof connector. Length 50m (165ft), Coaxial cable and incorporating strength members. Breaking strain in excess of ten times vehicle weight. Specific Gravity/Density 1.02 Breaking Stain 100kg (2201b) Power Supply On-Board Power: Nicad batteries. (SAFT VR 10) 10 x 1.2V = 12V at 10Ah Batteries removable by manufacturer only. Rechargable via umbilical cable connector and banana plug under vehicle handle. Duration: Approx. 2.5hrs without lights Approx 1hr using lights Charger Recharges C'Cat 12V 10Ah Nicad batteries and the control module 9.6V 0.5Ah batteries from nominal 120V 60Hz supply or nominal 240V 50Hz supply. Dependent upon customer selection of SAA or t.FL version. NOTE: Overcharge prevention is incorporated in C'Cat and control box and does not form part of the charger. Control Module 8 x 1.2V = 9.6V at 0.5Ah Nicad batteries, rechargeable through rear of module. Duration: Approx. 3hrs. Camera Auto iris , manufacturer interchangeable lens. Standard lens 6mm wide angle F1.4. The on-board vehicle camera is a colour sensitive Charge Coupled Device (CCD) able to withstand shock, impact and vibration. Light sensitivity 10 lux. Horizontal resolution: 250 lines for NTSC system and 280 lines for PAL system. Remote pan and tilt operation, also remote white balance correction. Voltage input 9.9 to 14.4V dc. Refer Sherwood Overseas Co. Pty Ltd approved specifications for National Camera Model WV- CDIIO/SP for NTSC system and Model WV-CDIIO/SE for the PAL system. Control Module Lightweight, multi-function, injection moulded plastic base incorporating: 1. Joystick control for operating fins. 2. Joystick control for camera pan and proportional forward/reverse speed controller. 3. Slide control for camera tilt. 4. Light on/off and intensity controlled from surface by slide control. 5. Remote control camera white balance by rotary pre- set panel control. 6. Light on control module panel indicates control module POWER ON. 7. Light on control module panel indicates underwater light ON or OFF. 8. Fine video balance rotary control. 9. Light ON / OFF switch located on top of left hand joystick. |