| Sales Rep | Extension |
|---|---|
| Allen | 225 |
| Moses | 232 |
| Derick | 231 |
 |
HS-400 Hot Pincette (For SMD) 100/120/230/240V Over the past few years electronic components have become smaller and PCBs have become more dense. Hozan's HS-400 enables maintenance of even these small-component high-density circuit boards with its pin-point technology without damaging surrounding components.  3-pin plugHand piece ESD protected. Operation like using tweezers. Surface
resistance 
Conductive lightweight plastic (42g).For either
right-handed or left-handed person.Power input 24V AC Power consumption Rush: 210W Normal: 40W Temperature range 210°C-600°C Dimensions 180X41X20mm Line cord 1.2m length Max. holding width 10mm Weight 125g (w/cord) 42g (w/o cord) Standard heater unit HS-405 Insulation resistance Class 2 Heater Unit The first model using SN heater. Reaches
350°C in 3 seconds. Rapid response provides quick operation.On-Off operation
only by switch on handle for safety and for saving electricity.Heatproof,
abrasion-proof, acid-resistant heater unit.Solder does
not stick to heater, especially desirable for micro-soldering.Station Automatic-recovery from short circuit on load. Heat recovery in seconds by On-Off time control circuit.RF noise regulated in accordance with FCC requirements.Temperatures of right and left heater units controlled by separate circuits.
Power input 100/200/220/240V AC 50/60 Hz Power output 24V Temperature control On-Off time control circuit Dimensions 116X86X247mm Weight 2.7kgs With excellent fast-heating performance, the SN heater raises the temperature along a steep characteristic curve and reaches the set temperature in an instant wen the remote switch is depressed. Moreover, the heater pattern is 3.5mm from the tip, eliminating problems with heat dissipation and making fast desoldering of chip components possible. Basic operations can be carried out quickly and easily! 1. Place the heater and hold. 2. Depress the remote switch. 3. Pick up. The HS-400 is designed for worldwide use! The input voltage can be switched to any one of four settings (100/120/220/240V). A slotted screwdriver is only necessary to adjust the voltage so that HS-400 can accommodate any voltage supply in any country throughout the world. Attachments that widen the functions and applications for hot pincette are also available. |
|